Epson TM-m30II (Bluetooth) receipt printer
On this page
Requirements
To use this hardware with your Shopify store, you need to meet the following requirements:
- use the Shopify POS app
- have a compatible iPad or iPhone that is running iOS 12.2
Where to buy the Epson TM-m30II receipt printer
The Epson TM-m30II receipt printer and printer paper are available from the Shopify Hardware Store insupported countries.
Shopify merchants in other countries can use the Epson TM-m30II receipt printer, but it's not sold through the Shopify hardware store.
For thermal roll paper specifications and an explanation of how to load the receipt printer, see the guide in the manufacturer'shardware manual.
Plug in your Epson TM-m30II receipt printer
Before you can use the Epson TM-m30II receipt printer, you need to connect your printer to the power supply.
Steps:
Remove the panel on the back of the printer.
Plug one end of the power cable into the back of your receipt printer.
Plug the other end of the cable into a power outlet and turn on the printer.
If the paper is loaded, then a diagnostic report prints.
一对and connect the Epson TM-m30II receipt printer with your POS device
To use the Epson TM-m30II receipt printer with Shopify POS, you need to pair the reader with your device through Shopify POS. After the printer and device are paired, the printer connects to the device automatically whenever both are powered on and in range.
Steps:
Connect your printer to thepower supply.
In the Shopify POS app, tap the≡button and then tapSettings.
利用Set up hardware.
利用Receipt printer>Epson>Bluetooth.
SelectEpson TM-m30II.
利用Connectand then完成.
Confirm that your printer shows up as connected underReceipt Printers.
After connecting your printer, don't forget to:
- Set it as the default printer(optional)
- Print a test receipt
- Test the connection to the cash drawer(if applicable).
ERROR indicator is blinking red
This is caused when there is no paper present in the printer. Open the printer, replace the paper, and close the lid. The ERROR indicator should stop blinking and the READY indicator should light up.
Paper jams
If you feed the paper into the receipt printer at an angle, then a paper jam is likely to happen. If this happens, then turn off the printer, open it up, and feed the paper in again.
If you're trying to make your receipt narrower than the specified 3 inch width, then make sure that you use the divider provided. Don't fold the paper when you feed it into the printer.
Customize receipts
You cancustomizeboth the basic receipt layout and the transaction description.